We would like to install solid slabs, and add risers

by

Q: Our house has engineered hardwood floors, and an open stair case (no risers). We would like to install solid slabs, and add risers. What would you recommend for risers? Is solid slab engineered hardwood (for this application) available?

A: I would suggest you get a stair professional for this work. It is complicated, and you want it to be done right.

Related Questions

  • Painting stringers and risers

    I have decided to sand and stain my treads one colour and paint the stringers and risers white. The stringers and risers are natural coloured oak veneer and have clear urethane on them. How would I go about painting the stringers and risers?

  • Install over top?

    I just purchased pre-engineered oak planks to replace wood flooring already installed. The flooring I need to remove is a tongue and groove floor glued down to OSB sub floor. I can't remove the glued floor without pieces of the osb coming up with it. What Should I do?

  • DIY Install of bamboo floor

    I am installing a bamboo floor that is 5/8" thick. I cannot find any place near me that rents an air powered flooring nailer (or shims to adjust a 3/8" or 3/4" ) to accommodate 5/8" thick flooring. How should I install it? Pre-drill and use a hammer and nail…

  • Staining before install

    Would it be easier to stain a new pine floor before it is laid? If this is the case, could we go ahead and give one coat of finish? The last part of my question is, would we have to stain the ends of the boards when we cut them…

  • Kitchen floor install

    I am wanting to install hardwood floors in my kitchen. My question is how this can be done with my dishwasher and trash compactor? How do you adjust for the height of the wood flooring to them. You can't just install the wood up to them as you would not…

  • Missed instructions for floor install

    I have installed a hardwood floor over particle board (with tar paper between). I thought I had read enough instructions before beginning, but somehow I missed that I shouldn't put the flooring over particle board. What problems can I expect? What are some solutions? I haven't finished the floor (It's…